วันเสาร์ที่ 20 กุมภาพันธ์ พ.ศ. 2553

Clean Scuba Diving - How and restore your Scuba Diving Gear


Image : http://www.flickr.com


Clean Diving equipment can be very easy if you know the correct procedures and if you use the right equipment cleaning. E 'also does not last long, 10-12 minutes tops. It 'very important to cleanse and disinfect the equipment, because a lot of bacteria, viruses and fungi inside and outside the corridor, if you can not grow properly.

You need to clean the equipment after each use of specially formulated for the use of chemicalsCleaning Diving Equipment, as a non-ionic detergent solution. This solution is used to build any contamination that can remove the regulator and other parts of your equipment. If left alone, this contamination could have caused harm to you or anyone else who can use your equipment.

To clean your scuba equipment, you need fresh water and a non-ionic detergent of your choice. Beginning with the regulators, is necessary before sprayingThe solution will be the mouthpiece and the second stage and the parts soaked surfaces. Do not immerse the non-ionic solution for 10 minutes. The solution may start to run low. When this happens, you must apply a solution. This is because the transmission needs for the entire 10 minutes, or wet, the solution is not completely all the germs and dirt will kill them. After 10 minutes is up, wash all parts of the second phase and the regulators in fresh water.

The cleaning BIBS MasksDiving equipment includes replacement of the BIBS mask from the tube and the dissemination of a great cloak of non-ionic detergent solution for each part of the area, including the tapes. Allow the cleaning solution to remain on the ground no less than 10 minutes. If the solution begins to dry, add more for the same reasons mentioned above.

Another piece of diving equipment that you want to do, clean and disinfect the oxygen chamberHood. The best method is to clean the entire inner surface of the dam neck and cap of the solution and allow to soak for a good 10 minutes, making a solution more than necessary. Sure to keep the surface wet for the entire 10 minutes. When 10 minutes and rinse the entire hood in a tub filled with water or running water, if you prefer. After it was thoroughly rinsed, then set it aside and let them air dry before being returned toCamera.

Disinfection and cleaning of the inner chamber is the last piece of diving equipment, which will be referenced in this article. Clean the inside of the room is not so complicated, if you know the right way to proceed. The best methods require that you clean and germ-free internal solution with the nonionic detergent in order to alleviate the bad impurities Rinse well and use a cloth dampened withSolution, then wipe the surface. Let the solution sit for 10 minutes before rinsing thoroughly.

Friends Link : Traveller Program japan culture tradition demons

ไม่มีความคิดเห็น:

แสดงความคิดเห็น